Recent content by smokeating

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. smokeating

    New UDS - Barrel Concerns

    Hey everyone, Been away for about a week traveling some parts of Texas(don't worry, we smoked a brisket and 3 pork shoulders on the journey in a WSM) but I am just overwhelmed to see the input here. Thank you all so much for responding to this thread and putting a few of my fears at ease. I...
  2. smokeating

    New UDS - Barrel Concerns

    Hey everyone, So I decided that I just needed to build a UDS. I figured the first step was to get my drum, so I got one for $13 and the vendor said that it originally had pine resin within it, however, after consulting with a couple of friends, we have come to the conclusion that it may not be...
  3. smokeating

    Questions for Smoker Mods

    Hey Dave, Thank you for the response, it is good to know I ordered the right things, however, in regards to sealing the gap of the door, I am actually wanting to seal the gap of the lid. While I feel that the 1/4" gasket would for sure be big enough for the door, I am just not sure it would...
  4. smokeating

    New from Austin, TX

    Hey everyone, I am a newbie here from Austin, TX. Just got a smoker(Master Forge Vertical Charcoal Smoker - basically an ECB) for Christmas this year and am looking forward to smoking here in 2013. I have been busy reading a lot about this little smoker and am now applying some of the many mods...
  5. smokeating

    Questions for Smoker Mods

    Hey everyone, I am new to the area of smoking as I just recently got a new smoker for Christmas (the Master Forge vertical charcoal smoker - basically an ECB). While I have already been having a lot of fun modding it out, I have run into a small snag and am in need some guidance from all of...
See more
Top Bottom
Back
Clicky