Recent content by ntrouble
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Help me plan my modification
It looks like I am finally getting ready to start working on my smoker renovation. After double and triple checking dimensions I wanted to run some basic ideas past the master builders here, if it is ok. Cook chamber dimensions are as follows: 23.5 inch interior diameter 32 inch seam to seam...- ntrouble
- Post #9
- Forum: Reverse Flow
-
Help me plan my modification
Well, I won't say I know how to fix any of this without wrestling with it for a while. I am grateful for any suggestions on what to do.- ntrouble
- Post #8
- Forum: Reverse Flow
-
Help me plan my modification
Hi Dave. The door was not installed correctly and the bullet hinges were removed last night. I will be addressing that issue as well. There is no doubt this thing will need a complete overhaul. Once I removed the hinges the door fit a lot closer. This is how it sits in the hole with no hinges.- ntrouble
- Post #6
- Forum: Reverse Flow
-
Help me plan my modification
Well that might help, huh? 24 inch diameter, 36 inches between the seams and 48 inches end cap to end cap. Firebox is 20x20x20- ntrouble
- Post #3
- Forum: Reverse Flow
-
Help me plan my modification
- ntrouble
- Album
- Comments: 0
-
Help me plan my modification
Hi. I have spent some time researching the threads here. I have picked up a smoker that is in need of some modification. I have decided to go ahead and do a full conversion to reverse flow. Now I need to plan out how to make the needed revisions. There are several challenges I see on this...- ntrouble
- Thread
- Replies: 10
- Forum: Reverse Flow
-
Opinions needed on this smoker
I would have thought the vertical box would be above the firebox so all the airflow would be traveling the same direction. As it is, the air flow will have to be split between the vertical cook chamber and the horizontal RF cook chamber. I am wondering if the design will allow for proper draw...- ntrouble
- Post #3
- Forum: Reverse Flow
-
Opinions needed on this smoker
- ntrouble
- Album
- Comments: 0
-
Opinions needed on this smoker
Hi everyone. I am shopping for a new smoker. I found this one and will probably look at it today. It is a little more substantial than I need, but that is only a minor concern. What I need for someone more experienced than me is an honest critique of this basic design. It just seems like there...- ntrouble
- Thread
- Replies: 2
- Forum: Reverse Flow
-
Smoker I built.
Bigugly, I have a suggestion. Considering all the time and effort you had to put in to get that cooker built, you really deserve to end up with an absolutely flawless rig that doesn't have all the "learning scars" that the first attemp will always have. So what you need to do in order to...- ntrouble
- Post #21
- Forum: Reverse Flow
-
Smoker I built.
That looks like a fine smoker. Great that you set it up to suit you.- ntrouble
- Post #19
- Forum: Reverse Flow
