Recent content by godscountry

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. godscountry

    Barrel Preparation

    T
  2. godscountry

    Barrel Preparation

    Thanks rib wizard. The skirting would definitely be easier to install, so I will probably go that route. You mentioned creating reverse flow inside the smoker. I've seen double barrel smokers with two pipes between the firebox and cooker, and then two exhausts on the sides.. Would that be...
  3. godscountry

    Barrel Preparation

    It could be done :D. It actually crossed my mind. I would rather do it right the first time. Do you know how well a 30 gallon drum would fit inside, if I would have enough room for insulation, and would that be a large enough firebox?
  4. godscountry

    Barrel Preparation

    A USD build probably would have been better but I already have money stuck into three barrels and some Vogelzang hardware. I was so excited about building a smoker that I just started getting supplies. It looked bigger so it must be better :). I might have to build a USD next winter if I get...
  5. godscountry

    First timer from SD

    Hey everyone. First time smoker from central South Dakota. Working on my first build and hopefully will be cranking out some good brisket, fatties, and chicken this summer. Thanks to everyone for their future help because I'm sure I will be using/needing it a bunch. I've already quadrupled...
  6. godscountry

    Barrel Preparation

    2010ultra- that's the type of smoker I was planning on building. Should have researched a little more because I've heard a lot of complaints about heat loss. Maybe would have built a single drum smoker instead. From what I've read the liner can't be burnt out. I've also read that it is a epoxy...
  7. godscountry

    Barrel Preparation

    Thanks for the input. I am new to the smoking world so I will probably be using this forum quite often. I will add a post in "Roll Call" later tonight Danny. I have my own sandblaster so blasting media and time is all I will have in it. So if I burn then sandblast, I shouldn't need to wash it or...
  8. Barrel Preparation

    Barrel Preparation

  9. IMG_20140326_182021_273.jpg

    IMG_20140326_182021_273.jpg

    • godscountry
    • Media item
    • Comments: 0
    • Album: Barrel Preparation
  10. IMG_20140326_181929_903.jpg

    IMG_20140326_181929_903.jpg

    • godscountry
    • Media item
    • Comments: 0
    • Album: Barrel Preparation
  11. godscountry

    Barrel Preparation

    I'm probably beating a dead horse with this thread. But, I'm Trying to build my first smoker and before I did to much research I bought a couple barrels with a red liner :(. I plan on sandblasting it out, but was wondering if someone with a little experience could help me in the order I...
See more
Top Bottom
Back
Clicky