Recent content by fireman00
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
2nd brisket wtih Q view - getting better with setting up the charcoal
I've got a Wal-mart special upright smoker with a couple of mods, made a burn pot with 1/2" steel grate for better burning and am using sand in the water pan. First brisket was tasty but not tender enough - had issues with keeping the temps from jumping around. First set of ribs (2-2-1) were... -
2013-07-28 19.57.35.jpg
- fireman00
- Media item
- Comments: 0
- Album: 2nd brisket wtih Q view - getting better with setting up the charcoal
-
2013-07-28 19.28.42.jpg
- fireman00
- Media item
- Comments: 0
- Album: 2nd brisket wtih Q view - getting better with setting up the charcoal
-
2013-07-28 13.03.00.jpg
- fireman00
- Media item
- Comments: 0
- Album: 2nd brisket wtih Q view - getting better with setting up the charcoal
-
Whats your favorite BBQ sauce?
KC masterpiece...since then over found a very nice recipe choose to their's. I just made a half gallon batch today. Sent from my DROID RAZR using Tapatalk 2- fireman00
- Post #52
- Forum: General Discussion
-
android market app?
Tapatalk works great. Sent from my DROID RAZR using Tapatalk 2 -
New ~No Weld~ Charcoal Pan for my ECB
Even though this is an older thread the mod still works! I just bought a Brinkman upright smoker adn I couldn' get the temp over 120 degrees. I picked up 2 sheets (12"x24") of the mesh, 4 ea. 1/4" x 1" screws with washers and nuts for under 40 bucks. I cut two 4" tall strips, bolted two...- fireman00
- Post #13
- Forum: Charcoal Smokers
-
IMG_0003.JPG
- fireman00
- Media item
- Comments: 0
- Album: New ~No Weld~ Charcoal Pan for my ECB
-
New ~No Weld~ Charcoal Pan for my ECB
- fireman00
- Album
- Comments: 0
