Recent content by bigsal51
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
18" smoker build with 5/8" firebox?
That's a good point on weight and hrs- bigsal51
- Post #8
- Forum: Smoker Builds
-
18" smoker build with 5/8" firebox?
- bigsal51
- Post #3
- Forum: Smoker Builds
-
18" smoker build with 5/8" firebox?
- bigsal51
- Post #2
- Forum: Smoker Builds
-
18" smoker build with 5/8" firebox?
- bigsal51
- Album
- Comments: 0
-
18" smoker build with 5/8" firebox?
Just finished a smoker for my buddy and he cringed when I told him 650$. As I'm making it I keep telling myself man this is a lot of work for a couple hundred bucks. The iron itself was expensive. The two end caps for the firebox alone were 48$ a piece. Sometimes I think I shouldn't make any for...- bigsal51
- Thread
- Replies: 8
- Forum: Smoker Builds
-
A Question for You Welders
Me either I actually sold it to a friend of mine- bigsal51
- Post #44
- Forum: Smoker Builds
-
A Question for You Welders
- bigsal51
- Album
- Comments: 0
-
A Question for You Welders
You know a lot of times we concentrate on the welder which is fine but that is only the start. Being able to cut and prep the iron is vital. I have been welding pits for the last 7 yrs in my garage and being able to cut 1/4in steel correctly without having to weld huge gaps has been the key to...- bigsal51
- Post #42
- Forum: Smoker Builds
-
Etching Primer??
I was reading a article on how to reprint a pit and they had etching primer for the pit. Will this work on our smokers to prime with?- bigsal51
- Thread
- Replies: 1
- Forum: Smoker Builds
-
What door should I cut on my new build
Thanks guys I guess I'll go with a traditional.- bigsal51
- Post #6
- Forum: Smoker Builds
