Recent content by barnesco
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Propane tank info
What's the correct way to purge a propane tank before you cut into it! Have a couple used tanks and sure don't want to cause an explosion when I cut into it. Thanks- barnesco
- Thread
- Replies: 1
- Forum: Side Fire Box
-
New builder
The sliding doors are nice for someone who is "vertically challenged", as my wife used to say. Don't have to reach up so high.- barnesco
- Post #17
- Forum: Reverse Flow
-
New builder
Jck, I sure hope not. I left quite a bit of clearance between the doors and the surrounding area. First sliding doors I have built. Just wanted something a little different. Have never seem any sliding doors before.- barnesco
- Post #14
- Forum: Reverse Flow
-
-
Hello from Texas
Hambone, Have posted a few pics on reverse flow smokers. Building one now -
New builder
I have been a welder and machinist since i was 16. I'm 67 now so I have several years of experience. After cutting out the doors I welded a 1/8" X 2" strip to the inside of the doors. Then used a 1" X 1" X 1/8" angle as a guide. Had to rip one edge of the angle down to 1/2" to get the clearance...- barnesco
- Post #9
- Forum: Reverse Flow
-
New builder
Working on the doors today. Trying my hand on sliding doors rather than lift up. Got one pretty much done. Still needs a little tweaking to operate properly. This photo shows the door half open- barnesco
- Post #7
- Forum: Reverse Flow
-
Dual RF Smokers on trailer....My first adventure
I don't use much acetylene anymore since I got my plasma cutter. Very nice and helpful tool. Should have gotten one years ago. Savings on acetylene would more than pay for it. Mine will easily cut thru 1" steel plate.- barnesco
- Post #86
- Forum: Reverse Flow
-
New builder
Have been working on the fire box today. Made a sliding vent.- barnesco
- Post #6
- Forum: Reverse Flow
-
250 reverse flow build
Cashmanq I know a few folks here on Houston that will do it for you.- barnesco
- Post #65
- Forum: Reverse Flow
-
-
New builder
- barnesco
- Post #3
- Forum: Reverse Flow
