removing the finish from a factory weber lid

Discussion in 'UDS Builds' started by ballagh, May 15, 2014.

  1. ballagh

    ballagh Smoking Fanatic

    Will sand blasting remove it. Cause my grinders, and sanders only polish it :)
     
  2. chiefusn

    chiefusn Smoke Blower

    Check out my Weber lid mods. I explain how I got down to bare metal in my video.



    Hope this helps. That coating is real sturdy and tough to get off. This is the only way I have been able to do it.

    Chad
     
  3. ballagh

    ballagh Smoking Fanatic

    sandblasting worked very well.  a little too well. actually warped the rim a little bit.  a little hammering on a sand bag brought her right back into place though.  just got it back from the powder coater and it looks amazing.  
     

Share This Page