I have the Brinkmann cook and carry. I did the charcoal pan mod over the weekend. Put legs of smoker on outside and constructed 3 legs for the pan. The legs connect to the rim of the charcoal pan. I ran into trouble due to the metal being so thin and flimsy the legs would bend all over the place. It's fine if it just sits there but put any side to side pressure and any one of the 3 legs will just bend where they connect at the rim of the pan. Is there anywhere I can get a pan that is a bit sturdier?
Where to get charcoal pan for Brinkmann??
- Thread starter lucc
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
lucc - i sent you a PM with suggestions that might help ~ i have three ECBs and the charcoal pans on those have the same flimsy "feel" when i put the legs on - i think it is simply par for the course ~
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
On the Edge of Trying Sausage Making
- Started by BrianGSDTexoma
- Replies: 35
- Sausage
-
Featured Blackened Rockfish...
- Started by Gonna Smoke
- Replies: 34
- Fish
-
Took a stroll this afternoon
- Started by Buckeyedude
- Replies: 33
- Field and Stream
-
Smokehouse Almost Done
- Started by BGKYSmoker
- Replies: 28
- General Discussion
