or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Charcoal Smokers › Would this work in my Smoke N Pit
New Posts  All Forums:Forum Nav:

Would this work in my Smoke N Pit

post #1 of 7
Thread Starter 
Hi All Has any one use this elbow in thier Brinkmanns Smoke N Pit..The OD looks kinda of big, not sure if "IT" would fit in the stack hole?
All I have there now is some rolled up light metal, thought this might work better.
Thanks Dan
http://www.homedepot.com/p/Master-Flow-3-in-90-Degree-Round-Adjustable-Elbow-B90E3/100112500#.UefXa7DD_rc
post #2 of 7

I have that one in my snp. I did cut a 3/4 inch piece and fold it out to put a screw through to the lid, for fastening it in the stack. It will fir better if you have a pair of shrinking pliers, found near the down spouts and gutters. The adjustable elbow is great.
post #3 of 7
Thread Starter 
Hi Shrinking pliers. Why would I need them? Will the elbow fit into the stack?
Thanks Dan
post #4 of 7
I went around the end with the pliers to make it fit. It doesn't take much work.
post #5 of 7
Thread Starter 
Hi I tried to use plain old pliers for the elbow job..What a PIA the part that goes into stack came off.NOw the elbow is sitting on the stack flange attached with Hi Temp Silicone..Got to check after it cures and see if the elbow will stay ttached to the flange, if not out comes the JB Weld.
I'm loving my SnP. A whole better then my vertical electric one.
Thanks Dan
post #6 of 7
Thread Starter 
Hi All So far the Hi Temp Silicone is holding, still has a few more hours for the full cure. Then onto the smoke stack.
Al ready for the Labor day smoke. Going to try brisket again, this time I will inject with beef broth,garlic n onion powder.biggrin.gif
I'm hoping thuis will cure my dry brisket from the past attempts.
Dan
post #7 of 7
Thread Starter 

Hi The Hi Temp silicone workedbiggrin.gif
Dan

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Charcoal Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Charcoal Smokers › Would this work in my Smoke N Pit