Okay. I'm going to start my new AMNPS for the first time. Exciting right? Ive got great suggestions from my friends here. In addition, Todd included good instructions that are easy to understand a straightforward.
Step one "The fun part".
Take out the torch and insert a LOW flame into the hole.
Step two. Make sure that you have the end of the opening completely lit.
Step Three. Blow on the end of the AMNPS to make the embers glow and then allow to burn outside the smoker for ten minutes.
Step Four. After ten minutes of burning I blow on the AMNPS again. The entire end is glowing. I'm assuming that it is well lit and I place it on the lower cross bar support on my MES 40.
I already like the thin blue smoke this gizmo is producing. Producing that quality of smoke wasn't always easy to achieve with the MES burner. BUT... this baby has hours to go yet. So we will see.
Edited by BDSkelly - 7/14/13 at 6:47am