New Posts  All Forums:Forum Nav:

Smoker

post #1 of 5
Thread Starter 

I have a Master Forge 2 door propane upright smoker. The bottom door is to make chip replacement when needed without losing all the heat in the top. Anyone with experience with these?

post #2 of 5

Bump.  

 

Sorry you didn't get a prompt answer.  I don't use one of those, but hopefully this will get someone's attention who does.

post #3 of 5

I have one, and several guys here, what's the Q?

post #4 of 5
Thread Starter 

Thanks to SMF guys I have added a gasket to the doors of my smoker. Used a Rutland Grapho-Glas 1/4"

rope type gasket & Rutland heat resistant.adhessive. Also put talc. pwder. on the outside so the gasket

so it would not stick to the frame of the smoker. Makes the door harder to close, but sealed good.

 

I found the gasket at a Mom & Pop (we have everything there is) type of hdwe. store. Was not carried

by Lowe's Hdwe. Don't know about Home Depot. You could probably order from Rutland. So far so good,

& hope it will help others.

 

post #5 of 5

Quote:
Originally Posted by golfboy View Post

I have a Master Forge 2 door propane upright smoker. The bottom door is to make chip replacement when needed without losing all the heat in the top. 100% correct

Anyone with experience with these?


I have one and will be glade to help you out if I can

 

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Propane Smokers