Recent content by timbercop

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. timbercop

    new build with some questions

    I used a small torch to heat the tar and scrape it off. I only went after the thicker parts since I'm using Roxul insulation. It worked like a charm.
  2. timbercop

    new build with some questions

    What would be the best to put in between the inner and outer to cover the insulation on both the door and inner and outer tub.
  3. 20150915_133057.jpg

    20150915_133057.jpg

  4. timbercop

    new build with some questions

    Inner tub with racks started
  5. 20150915_133246.jpg

    20150915_133246.jpg

  6. timbercop

    new build with some questions

    Thus far pics with some additional questions
  7. new build with some questions

    new build with some questions

  8. 20150915_133325.jpg

    20150915_133325.jpg

  9. timbercop

    new build with some questions

    Making some progress on it. I'll have some pics in a day or two.  Thanks for the ideas. 
  10. timbercop

    new build with some questions

    Hey folks, acquired an old Admiral fridge the other day and started breaking it down.  It is a pretty good set up with some minor rust in the bottom.  I browsed through the forum the other day and picked up a few ideas, but didn't see these questions.  I hope they aren't too bad of a repeat. ...
  11. timbercop

    Newbie 200 gallon RF build

    Thanks Dave.  I'm certain I'll be back on in a few days with a question or two.  I'll get some other pics as well.  
  12. IMG_0016.JPG

    IMG_0016.JPG

  13. IMG_0017.JPG

    IMG_0017.JPG

  14. IMG_0017.JPG

    IMG_0017.JPG

  15. IMG_0018.JPG

    IMG_0018.JPG

Clicky