new smoker question

Discussion in 'Other Builds' started by shaneb7, Nov 17, 2014.

  1. I plan to run a pid because my temp is all over the place can I wire the element around the switch and just use my pid for controlling temp their is somthing going on with the switch I think I would just like to go around it any suggestions would be greatly appreciated thanks
     
  2. smokin monkey

    smokin monkey Master of the Pit Group Lead OTBS Member SMF Premier Member

    Hi Shane' I built a electric smoker with a PID. I used a relay to power element.

    Smokin Monkey �
     
  3. Ok thank you I was just going to buy a plug and play dual prope pid but my heating element has a switch problem so It was wandering if I can do away with the switch beings it will be plugged in to my pid so basically the element will be wide open and I should be abel to control with pid without burning any thing down rite
     
    Last edited: Nov 18, 2014

Share This Page