Made from a $3 silicone spoon rest. Another matching piece on the inside. On my UDS-30. The probes for my new Flame Boss wouldn't fit through the hole I had for the Maverick probes.
Probe Wire management
- Thread starter damascusmaker
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Check out a "cable entrance connector" in the electrical dept. at Lowe's. They are only a couple of bucks and have a rubber grommet inside to protect the probe wires. I have never had a problem with mine. Several of the custom builders use this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Instant Pot help, my first try was a fail.
- Started by forktender
- Replies: 25
- General Discussion
-
Homemade Chili + Cinnamon Rolls = WOW
- Started by yankee2bbq
- Replies: 21
- General Discussion
-
Red's Santa Maria Build - A Custom Grill for JIMSMOKES!
- Started by seenred
- Replies: 19
- Other Builds
-
Sunday smoked butt on the drum
- Started by TimboBBQ!
- Replies: 16
- General Discussion
