Just received my smoker-not out of box yet. Began to think about assembly-how much assembly is there on this Masterbuilt Electric smoker? Looks like a lot from the online manual!
MES 40" -how much assembly?
- Thread starter annaceil
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Howdy, Anna! Welcome to the Smoking Meats Forums from Texas!
I've had my MES long enough that I don't remember how much is required to get it ready for use, but it was not bad.
Of course, I've reached the age where I can hide my own Easter Eggs, too!
:yahoo:
I've had my MES long enough that I don't remember how much is required to get it ready for use, but it was not bad.
Of course, I've reached the age where I can hide my own Easter Eggs, too!
:yahoo:
It's not bad, Anna----Good directions & only need one tool---Phillips Screw Driver. (Plus a scissors or knife to cut ties & open things).
Be careful---I could see it falling on it's face if you aren't careful opening the door before you put the bottom parts on.
Bear
Be careful---I could see it falling on it's face if you aren't careful opening the door before you put the bottom parts on.
Bear
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Spammer PMs, Anybody Else?
- Started by chilerelleno
- Replies: 65
- Blowing Smoke Around the Smoker.
-
Lost my dad yesterday
- Started by normanaj
- Replies: 40
- Blowing Smoke Around the Smoker.
-
On the Edge of Trying Sausage Making
- Started by BrianGSDTexoma
- Replies: 35
- Sausage
-
Took a stroll this afternoon
- Started by Buckeyedude
- Replies: 33
- Field and Stream
