Toggle sidebar

UDS Lid glue

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
dcmak

dcmak

Newbie
Original poster
Jan 11, 2014
24
11
Ok I'm all but done with my build but the lid gasket is not cooperating. Some sections came right off but I have about 18 inches I just can't get the glue/silicone off that is holding the gasket.. Thanks in advance
IMAG2149.jpg

IMAG2149.jpg

 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

SmokingUPnorth
Kettle vent handle melted.
Replies
5
Views
325
Blowing Smoke Around the Smoker.
chopsaw
chopsaw
Its_Raw
Leaking Smoker Lid and Temperature Variances
Replies
5
Views
455
General Discussion
DougE
DougE
chopsaw
Another " Gut instinct " Goodwill score .
Replies
9
Views
366
Blowing Smoke Around the Smoker.
chopsaw
chopsaw
P
Heating element tripping GFI outlet
Replies
5
Views
1K
Masterbuilt Electric Smoker (MES) Owners
Nefarious
N
F
Slicers w Sharpeners
Replies
7
Views
301
Slicers, Grinders, Tools, Equipment
sawhorseray
sawhorseray
chopsaw
Sourdough Practice ( for this week )
Replies
32
Views
729
Breads
chopsaw
chopsaw
hooked on smoke
MB gravity power supply
Replies
2
Views
504
Blowing Smoke Around the Smoker.
Smokin Okie
Smokin Okie
joepeep77
Barrel for a UDS
Replies
0
Views
725
Smoker Builds
joepeep77
joepeep77

Latest posts

Hot Threads

Top Bottom
Back
Clicky