Toggle sidebar

The Mud Pit II is born: 275 gallon reverse flow build

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
image.jpg

image.jpg


Firebox bout done. As you can see I'm lacking on the bottom. Started to run out of plate, I'll splice 2 on the bottom. On the bottom of the one side i will have the air intake there
 
image.jpg

image.jpg


Ran out of oxygen, but still had time on my hands. Figured I'd go ahead and connect the two and finish the box when I get more oxy
 
http://www.smokingmeatforums.com/content/type/61/id/289043/width/200/height/400[/IMGg

So far...
 
image.jpg

image.jpg


Got door marked out. Might be putting the cart in front of the horse, but I put the door hinges on. Last build I did I had a heck of a time lining to install back on cooker. Did some cuts where the hinges went and put them on. Then cut the rest
 
I have 22" between bottom rack and to of door opening. Do I have enough room for 3 racks ( 7 1/2" roughly between racks) or am I asking for trouble
 
RW, you took the words right out of my mouth, you can use either, I use angle.

Gary    ...........................    Good job, looks great !!!!!!
 
If you use angle what keeps the rack from flopping out when it slides out?
 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Top Bottom
Back
Clicky