Recent content by rapscallion
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Building a smoker...
Temporary wheel placement and attached the tongue. Getting closer to the cook!!!- rapscallion
- Post #28
- Forum: Reverse Flow
-
20140402_164528.jpg
- rapscallion
- Media item
- Comments: 0
- Album: Building a smoker...
-
Building a smoker...
- rapscallion
- Post #27
- Forum: Reverse Flow
-
20140329_090543.jpg
- rapscallion
- Media item
- Comments: 0
- Album: Building a smoker...
-
Building a smoker...
- rapscallion
- Post #26
- Forum: Reverse Flow
-
20140329_112004.jpg
- rapscallion
- Media item
- Comments: 0
- Album: Building a smoker...
-
Building a smoker...
Here are some pics of the build so far.- rapscallion
- Post #25
- Forum: Reverse Flow
-
Building a smoker...
Hi! It's been a while I had to put my build on hold for a bit. But now I am back to finish it and start cooking!!!! I have a question for you folks. After all the math has been done and I am to a point of installing the chimney the length is 44" tall. I have been looking at some of the builds...- rapscallion
- Post #23
- Forum: Reverse Flow
-
Building a smoker...
If I were to run dual stacks how will that effect the air flow? Do I need to go with a smaller diameter?- rapscallion
- Post #22
- Forum: Reverse Flow
-
Building a smoker...
Is it a bad thing to build the firebox a little bigger than whats called for?- rapscallion
- Post #19
- Forum: Reverse Flow
-
Building a smoker...
The next big question is can I cut out the door and start prepping the inside? Any special tricks for that??- rapscallion
- Post #14
- Forum: Reverse Flow
-
Building a smoker...
- rapscallion
- Post #13
- Forum: Reverse Flow
-
IMAG1340.jpg
- rapscallion
- Media item
- Comments: 0
- Album: Building a smoker...
-
Building a smoker...
- rapscallion
- Album
- Comments: 0
-
Building a smoker...
- rapscallion
- Post #12
- Forum: Reverse Flow
