Recent content by craigbn

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. craigbn

    Homebuilt propane smoker

    dial reading, I think the probes not far enough inside the smoker!
  2. IMG_1059.jpg

    IMG_1059.jpg

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
  3. craigbn

    Homebuilt propane smoker

    digital reading
  4. IMG_1056.jpg

    IMG_1056.jpg

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
  5. craigbn

    Homebuilt propane smoker

    Temperature check with out door gasket and lower burner door
  6. IMG_1061.jpg

    IMG_1061.jpg

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
  7. craigbn

    Found a burner for smokehouse

    Hey Pops, so do you think the valves on your burner are getting sticky because it's in an enclosed area at higher temps?
  8. craigbn

    Homebuilt propane smoker

    So im contemplating if I should build a door for the burner compartment. The wood chip pan seals off the upper section to the lower compartment so I shouldn't have any heat loss. Im curious if the burner setup I have from northern tools is ok to be in a inclosed area at higher temps? The only...
  9. craigbn

    The "No Name" smokehouse

    Very nice job!
  10. craigbn

    Homebuilt propane smoker

    And the dolly wheels done!  I think the build is probably up to 350lbs
  11. P1250349.JPG

    P1250349.JPG

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
  12. craigbn

    Homebuilt propane smoker

    So i got the gate valve done on the chimney, the chip pan done!
  13. craigbn

    Homebuilt propane smoker

  14. P1250346.JPG

    P1250346.JPG

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
  15. P1250347.JPG

    P1250347.JPG

    • craigbn
    • Media item
    • Comments: 0
    • Album: Default
See more
Top Bottom
Back
Clicky