hobart 1612 slicer

Discussion in 'Slicers, Grinders, Tools, Equipment' started by stinnettjb, May 9, 2016.

  1. stinnettjb

    stinnettjb Newbie

    I have what I believe to be a Hobart 1612 slicer I bought at an auction. The thickness knob will not turn. Any ideas on how to fix it?


  2. rexster314

    rexster314 Meat Mopper

    A common problem with these slicers. When I got mine 2 years ago, it was stuck so bad I eventually had to turn to a propane torch and a dead blow hammer to loosen it up in order to clean it. Most of the problems arise when the previous owner used a PAM like product to lubricate the guide rods. When this stuff is exposed to air and dry out, it becomes the gummiest stuff you've ever seen. I found this when I was searching the web on how to fix this problem


    Hope this helps

Share This Page