We have a Masterbuilt vertical electric smoker. Quite a bit of rust has developed inside.
Is sanding and painting the inside a no-no?
Thanks.
Is sanding and painting the inside a no-no?
Thanks.
Rust inside vertical smoker
- Thread starter jmuenchow
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
kruizer
Master of the Pit
I would not paint the inside of your smoker. Use a stainless dish scrubbie to clean the rust and then keep the inside oiled with a good veg oil between smokes.
That’s kind of what I planned. We neglected it on a patio for a while. Won’t make that mistake again! The rust is that bad, so I’m going to give it a shot. Fingers crossed!!
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 57
- General Discussion
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 42
- Blowing Smoke Around the Smoker.
-
Non fat dried milk
- Started by hog warden
- Replies: 37
- Sausage
-
Featured A couple thick strips please!
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
