Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
HELLO ALL in a reverse flow the plate inside the cooker does it have to be flat or the v type or can it be like a c channel thats whats is going in mine right now its a 1/2'' truck frame and why are they the v type
In mine there is a piece of angle Iron in the middle, welded to two plates on either side. the angle is welded in like a v and is a grease drain, so it does have a slight slope to it. It is attached to a pipe which runs down and out of the bottom of the cooker, I put a small pail under it to collect grease.