Propane tank table Top

Discussion in 'Propane Smokers' started by richoso1, Jun 8, 2008.

  1. richoso1

    richoso1 Smoking Guru OTBS Member SMF Premier Member

    Well, the electrician left a piece of scrap plywood and I just had to find something to do with it. My propane caddy has some room around the tank, but not enough to put a plate/pan/rack on. So I decided to make a tabletop that would fit over the tank. It’s almost a pressed fit, so not much chance of it tipping over. I added a few support blocks just for more stability and left the front open to remove/attach the regulator. The middle part is open so I can shut-off the gas as before. Gave her the same stain as the propane caddy, just to keeps things uniform. To remove the top, I just pull it straight up. The tank also just pulls straight up from the caddy. GOT NACHOS?
  2. erain

    erain Master of the Pit OTBS Member SMF Premier Member

    that center plate matches your avatar pretty close!!!!
  3. ronp

    ronp Smoking Guru OTBS Member SMF Premier Member

    Nice job, very creative on your part.

Share This Page