door trim

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

spideywren

Newbie
Original poster
May 14, 2008
6
10
Peculiar mo
I have a smoker made from an old tar wagon and it has a big door on both sides and I was wondering what I could use to somewhat seal these up. I lose quite a bit of smoke and heat through the gaps and it has gotten worse since my little mishap. I was taking it to a buddies last 4th of July and it gave unhitched from the back of my pickup and ended upside down in someones yard at 0500. I was not happy but I managed to bend the doors back most of the way.

Any thoughts would be a big help.


PDT_Armataz_01_39.gif
Thanks Robbie
 
Then after that use some fiberglass gasket rope.....Either the round rope or the flat tape rope should help fill in ...................
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky