Ok, I have been wanting to add one of these to my OK Joe smoker and finally got a piece of steel to do so. I have been reading the posts here and they always help but I have a couple of questions:
1. I have a piece of steel 36" x 11" that is 1/4" thick should this be good?
2. Is there a specific way that works best?
3. Are you supposed to use specific hole sizes for the best results?
4. Should a specific number of holes be made?
5. Is there a template that someone has to help lay this all out?
6. Does the on end need to be bent up at an angle at the fir box end or is it OK straight?
7. How does one go about bending the steel?
Thanks in advance.
Link
1. I have a piece of steel 36" x 11" that is 1/4" thick should this be good?
2. Is there a specific way that works best?
3. Are you supposed to use specific hole sizes for the best results?
4. Should a specific number of holes be made?
5. Is there a template that someone has to help lay this all out?
6. Does the on end need to be bent up at an angle at the fir box end or is it OK straight?
7. How does one go about bending the steel?
Thanks in advance.
Link