Cold Smoke Generator

Discussion in 'Slicers, Grinders, Tools, Equipment' started by peculiarmike, Nov 21, 2007.

  1. peculiarmike

    peculiarmike Master of the Pit OTBS Member

  2. cajun_1

    cajun_1 Master of the Pit OTBS Member

    Wasn't there a thread earlier about this ??? Isn't he a member here?
     
  3. peculiarmike

    peculiarmike Master of the Pit OTBS Member

    Could be, don't know. Just happened on it and thought it was interesting.
     
  4. navionjim

    navionjim Smoking Fanatic OTBS Member

  5. wavector

    wavector Smoking Fanatic

    I love and miss Chicago.

    [​IMG]
     
  6. wavector

    wavector Smoking Fanatic

    Only problem I see is the galvanized parts they are using (i.e. the threaded nipple they are using is galvanized or GRC for short).
     
  7. To answer the post there is NO galvanized pipe used in the making of this unit. It is made from aluminum and the end caps are cast aluminum. The threaded nipple is all steel. There may be a couple of pictures showing a galvanized nipple from when I first made one, but the ones I’ am making are GRC free. From the research I have done you have to get the galvanized up over 900 degree before any gases are released but to be safe I stayed away from using it.
     

Share This Page