Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. P

    MES PID Mod

    Here's my update This weekend I double checked my thoughts on this and they were correct all I had to do to be ready for the PID was disconnect connector 1 and connect it to connector 2. After connecting connector 1 to connector 2 I reinstalled the covers hooked up the PID and ran the auto...
  2. P

    MES PID Mod

    Thanks for all the great advice hopefully I'll get chance to work on it this weekend and get time to figure out the Auber
  3. P

    MES PID Mod

    dwdunlap this was not posted as instructions only to get feedback from the ones who know. I have no experience with any model but the one I have.
  4. P

    MES PID Mod

    In the picture labeled cable entrance, connector 1 comes from the power cord and goes to the electronics panel, connector 2 comes from the electronics panel and one wire goes to the temp cutoff switch and the other goes to the heat element the two connectors are the same allowing me to plug...
  5. P

    MES PID Mod

    Here's the pics
  6. P

    MES PID Mod

    I'll get some pics posted, if what thinking is right you won't even have to cut a single wire and you can change it back to original by swapping the connectors back.
  7. P

    MES PID Mod

    My unit is totally different than any I have seen posted. The connector on the power cord is the same as the one that goes to the heat element and safety switch I ohmed them out with a meter. If I connect as described above the safety switch is still in the circuit but is breaking the neutral...
  8. P

    MES PID Mod

  9. P

    MES PID Mod

    This is my first post but I have been hanging out here for awhile. I have a MES 30" model 20077915 which I primarily bought to make summer sausage and snack sticks after my first couple of attempts I have quickly discovered that the huge temperature swings of the MES are not very good for...
  10. P

    Auber Instruments PID Controller

    Is this still available
Clicky