Recent content by thunderjosh
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Backwoods Clone I just finished Up!!!!
Very impressive, my fire box and high heat areas are 1/8" and angle iron frame. 16 gauge guts with 3.5" of 2500 degree thermafiber wrapped with aluminum. I can run 13 hrs on 17 lbs of lump @ 225. In the middle I'm dead on 225 front and back with maverick and a mypin temp control. From top to...- thunderjosh
- Post #13
- Forum: Charcoal Smokers
-
Backwoods Clone I just finished Up!!!!
Great looking smoker looks like my build. How do you like the fire box divider? And how does it work? Since I seen yours I'm been thinking of a divider. Thanks- thunderjosh
- Post #11
- Forum: Charcoal Smokers
-
MYPIN TA4 PID manual, programming instructions and general PID/SSR info - by request
How low does your temp get before the fan turns on? At bbq comp I run 225 degrees, I fired my smoker with outside temp of 40 degrees and the fan runs constant till 221 degrees. Then pulses till 225 and shuts off. After it shuts off I hit temps 30-40 degrees over because it stoked the fire so...- thunderjosh
- Post #46
- Forum: Smoker Builds
-
image.jpg
- thunderjosh
- Media item
- Comments: 0
- Album: MYPIN TA4 PID manual, programming instructions and general PID/SSR info - by request
-
image.jpg
- thunderjosh
- Media item
- Comments: 0
- Album: MYPIN TA4 PID manual, programming instructions and general PID/SSR info - by request
-
MYPIN TA4 PID manual, programming instructions and general PID/SSR info - by request
Hello I have the mypin ta7 and the issue I'm having is the blower runs almost to my desired temp and starts pulsing at about 4 degrees before, then I way over shoot my desired temp. I would like it to start pulsing around 20 degrees before my desired temp not 4. How do I set this. This is set...- thunderjosh
- Post #44
- Forum: Smoker Builds
