Recent content by pmush

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. pmush

    Another NEWBIE (Northern Michigan)

    Made more progress today.  Installed the door gasket, added a second burner (so I can run 120 volt), and did another dry run.   Next step I to install rack system and hangers bars along with a slab in the bottom for counter weight and heat sink.  Once that in done the drip pans, fan, and smoke...
  2. Stat 2 Bottom.jpg

    Stat 2 Bottom.jpg

  3. Stat 1 Top.jpg

    Stat 1 Top.jpg

  4. Over All 2.jpg

    Over All 2.jpg

  5. Over All 1.jpg

    Over All 1.jpg

  6. Open Door 4.jpg

    Open Door 4.jpg

  7. Open Door 1.jpg

    Open Door 1.jpg

  8. Open Door 2 Gasket.jpg

    Open Door 2 Gasket.jpg

  9. Double Burner 2.jpg

    Double Burner 2.jpg

  10. Double Burner 1.jpg

    Double Burner 1.jpg

  11. pmush

    Another NEWBIE (Northern Michigan)

    No just a few long cracks. i may even end up covering the lower portions of glass with some sheet metal to form a heat shield. by the time i put in drip pans most of that area will not need to be seen anyway.
  12. pmush

    Another NEWBIE (Northern Michigan)

    I am in Traverse City. Thanks for the tip. I have the fan just working my way through the process. I was not really sure what would happen when i put heat to the freezer so i wanted to warm it up before putting in too much work and money. I got a little greedy with the first heat. Luckily...
  13. Pic 1.jpg

    Pic 1.jpg

  14. Pic 2.jpg

    Pic 2.jpg

  15. pmush

    Another NEWBIE (Northern Michigan)

    After rehanging the doors today I filled the void with insulation to do a temperature test.  All in all it went well with one minor glitch.  I ran the unit up to 300deg just to make sure I will not have any troubles cooking at 225 for long periods and if anything was going to go wrong I wanted...
Clicky