Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Albums for user: wingnut
Check out all albums created by wingnut
It's just two pieces of expanded metal, each bent into a "U", and then you sit one on top of the other offset so you have a double thickness bottom, and 4 sides. Set your MIG Welder very low and...
Ok it finally came up full
The picture did not show in full cause I would like to make it . A picture is worth a thousand words to me. Lol
Bacon looks great. Post the recipe.
- Uploaded Media:
- Embedded Media:
- Disk Usage:
- 32.9 GB