or Connect
New Posts  All Forums:Forum Nav:

Smoke generator...

post #1 of 5
Thread Starter 
Here's a trial version of a smoke generator out stock plumbing parts.
It ran for about 2 hrs. Problem was the wood chip kept bridging and had to tap on it about every 20 minutes.
2-2 x Clos nipple
1-2 x 6 nipple
1-2 x 1/2 tee
1-2 x 3/4 tee
1-2 cap
Expanded metal mesh welded in bottom nipple'

After messing with it for a while, figured out I didn't need the 2 x 1/2 tee at the bottom.
Now I am going to make one with 3" pipe without fittings so it won't bridge and runs longer. I'll post some pics later.
If anyone has pics and suggestions it would greatly be appreciated.
post #2 of 5
Looks like you're off to a good start and that looks like I fine generator... I say this because for me, the first build is usually just the beginning!

If you do a little searching, you'll find where others have attached an aquarium pump to theirs. I built on that is basically the same concept as your's, only I used square tubing.

At some point, I am going to hook up a pump to mine.
post #3 of 5
post #4 of 5
Thread Starter 
Hell Fire Grill,
I did a search and must of missed it.
That's pretty cool. PDT_Armataz_01_34.gif Is that 3" pipe and about how long is it? icon_question.gif
Do you use dry or soaked wood chips?icon_question.gif
Thanks that a great link.
post #5 of 5
Looks to be a good design...PDT_Armataz_01_34.gif
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Other Builds