- May 5, 2007
- 2,838
- 16
Okay, I got bored, my mind went on overload, so I decided I needed to fix my digital thermometer cable entry problem into the chamber on my CG. I hated running the cables through the lid and body lip... it made the lid lift up and leak, plus the cables get kinked. Well here's my solution, with little to no smoke/heat leakage:
First, a 13/16 hole cut into the chamber body, just below the lip
Here's a couple of shots of the piece I used:
Unit installed:
I used a 1/2" NM/SE (UF) Cable Connector #49092 at Lowes. I had to shorten the body of it about 1/16" or so, and shortened the rubber seal inside about 1/8". This gave me the ability to tighten the unit against the body.
I ran 4 cables through there after installing it with no problem at all. I think this is gonna work out great!
Stay tuned...
First, a 13/16 hole cut into the chamber body, just below the lip
Here's a couple of shots of the piece I used:
Unit installed:
I used a 1/2" NM/SE (UF) Cable Connector #49092 at Lowes. I had to shorten the body of it about 1/16" or so, and shortened the rubber seal inside about 1/8". This gave me the ability to tighten the unit against the body.
I ran 4 cables through there after installing it with no problem at all. I think this is gonna work out great!
Stay tuned...