just another gravity feed clone

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

chelgen

Newbie
Original poster
Feb 26, 2017
2
10
good evening all, just a few pictures of my current build. 5 shelves 30x32 5" spacing. frame is 2x2 12g, inside sheeting is 12g, outside skins will be 14g hopefully done in the next couple weeks. the fire box is 12x12 1/2" with a 1/4" tapered coal chute. the insulation is 2" roxul 8# mineral board. hopefully itll work like its supposed to without to much messing with it. feel free to critique or provide recommendations, this is the first one like this, my other one was a trailer mounted 120 Gal fuel oil tank.   














 
 I can see a lot of hard work has gone into that smoker.    

Are you going to make the stack so it rotates?   That way you can adust for any wind.
 
Thanks still working to get the air flow right to bring it up to temp. The stack will rotate just need to loosen the clamp a bit
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky