Pit Barrel Smoker - Brisket

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

thebaum

Newbie
Original poster
Mar 10, 2017
5
10
The pit barrel site advises 6 hours +/- for a brisket.  I smoked a 10 lb brisket and it took about 9 hours to reach 200F internal temp.  I need to smoke a 15 hour brisket this weekend and am trying to figure out how long this may take.  Any thoughts on (1) why it took me 9 hours the first time and (2) how long for a 15 lb brisket?  Thanks.
 
welcome1.gif
 to SMF!

To try and answer your often debated question, you can't cook a brisket to time on a consistent basis.  Most all meats have their own mind of when they will be done.  How the meat was handled, fat content, etc. all determine how long it takes to get to the level of done that you prefer.

Smoking at 225° you can plan around 1.5 hours per pound, or 22.5 hours!  Do I think it will take that long?  NOPE!  But again, it depends on the meat...  One good thing about brisket is it holds really well when wrapped in foil and placed into a warm ice chest.  I've held for over 6 hours and it was still too hot to hold bare handed.
 
Thanks for the quick feedback.  I think I'll plan for a longer smoke and use the ice chest if it comes off early.
 
This is the best bbq I ever had ...watch the 3 part brisket guide...follow it , and it will be perfect...I do 250 degrees,always pretty perfect.

 
Last edited by a moderator:
I wrap in foil with stout at 160-165. It took about six hours just to get to this point. Wondering if I need to open the vent more.
 
My 12lb pre trimmed brisket is at 148 after 7 hours. How does the PBC website suggest 4-6 hours with a 16lb brisket???

Sent from my Nexus 7 using Tapatalk
 
My 12lb pre trimmed brisket is at 148 after 7 hours. How does the PBC website suggest 4-6 hours with a 16lb brisket???

Sent from my Nexus 7 using Tapatalk

Briskets and butts have a mind of their own. But, once they pass the stall, they tend to take off. The only numbers you can trust are the ones on your thermometer, and even then, you'll still want to probe test for tenderness.
 
I believe part of the problem is that the ashes start to prevent air flow underneath the basket. Even though you may keep adding coals for the long smoke, you are getting less heat. I tried smoking tri-tip after a 10 hour brisket smoke. Usually takes 50 minutes, this time it took over three hours.
 
Yeah I was thinking that the pan doesn't give much air flow. Trouble is, not much room to raise it up.

Sent from my HTC One_M8 using Tapatalk
 
You can leave it in the cooler for several hours. I don't know if the temp will rise though. I would throw more coals in, open the vent all the way and hope for 200.
 
After removing from the oven I left it overnight in a cooler. I put it in the fridge then warmed it back to 140 or so later in the day. All things considered it turned out really good, my best yet.
So, lessons learned? Put it on overnight and plan for a wee bit longer than six hours.
As mentioned previously I may need to adjust the intake slightly to generate more heat.


Sent from my HTC One_M8 using Tapatalk
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky