My new reverse flow "Frankenstein" is just about done, made out of a 250 gallon air compressor. should I burn it out before paint? Whats correct process for paint and seasoning? Any help would be greatly appreciated.
new reverse flow build paint question
- Thread starter dveeusrod
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
My new reverse flow "Frankenstein" is just about done, made out of a 250 gallon air compressor. should I burn it out before paint? Whats correct process for paint and seasoning? Any help would be greatly appreciated.
jhsdigital
Smoke Blower
I used a high temp engine block primer first, I purchased it from an auto parts store. Then I sprayed it with a high temp flat black rustoleum paint from Lowes, it's going on about 3 years now and still holding up fine. I did however rub it down with WD40 after the original coat of flat black paint had dried and have done additional wipe downs about every year or so.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Chorizo or Sausage? Help a newbie!
- Started by I-am-Chorizo
- Replies: 51
- Sausage
-
Ready For The Farmers Mkt
- Started by BGKYSmoker
- Replies: 24
- General Discussion
