Finally Done

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

deere317

Newbie
Original poster
Sep 13, 2016
8
10
cincinnati
It took longer than I though but here it is fellas
 
Last edited:
Thumbs Up ... excellent build... question on the exhaust stack ... Is the square tubing cut to the arch of the round end or is it still square and inserted through a slot cut in the bell end ?? and then what ever size hole cut in the tubing for proper size vent ?? `
 
  • Like
Reactions: deere317
I cut the end of the tank bell from the top of the tank to the top of the firebox. I can't remember off hand what size opening I cut in the square stock for the flue but it was whatever the smoker calculator suggested. There's a few things left to do on the build I have to weld a front handle on come up with some sort of chimney damper and fabricate a swing out workstation/ counter
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Clicky