post #1 of 1
Thread Starter 

Hi

I am in the early stages of planing my first reverse flow build. 

 

The compressor I have purchased is somewhat bigger than what I had in mind at 1900l or 500 gallons but it was the best one I could find.

 

I was not planning on making a trailer but think with this tank it makes sense? 

 

 

Given it is so much bigger than I had planned I though I would make the smoking chamber and firebox out of the same tank. From what I gather from the calculators if I cut the tank into a 1.5m section for the smoking chamber and a 500mm section for the firebox the proportions should be about right.

 

I have a mig but I figure I am really going to need a plasma cutter for this project. Any thought on if any of the cheaper cutters are worth while?

 

Any thoughts?

 

Thanks