or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Cutting door from propane tank
New Posts  All Forums:Forum Nav:

Cutting door from propane tank

post #1 of 2
Thread Starter 

I was thinking about cutting the top section of the door, then welding on hinges, and finish by cutting sides and bottom.

Is this a good idea, or is it recommended to cut out the complete door first then install hinges? Thanks in advance for your thoughts,

Steve

post #2 of 2
Hi Steve. When I cut my door I made the top cut then tacked on the hinges. Then last I made the side and bottom cuts. No need to try and hold door in place when welding on hinges. It worked out really slick. Hope this helps
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Reverse Flow
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Cutting door from propane tank