SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Propane Smokers › Flame color on Landmann GOSM 3405GLA ?
New Posts  All Forums:Forum Nav:

Flame color on Landmann GOSM 3405GLA ?

post #1 of 13
Thread Starter 

Today I'm cleaning out the cobwebs from my Landmann 2-drawer 3405GLA propane smoker and getting ready for first smoke of Spring (brisket). I'm letting it come up to temp to just clean out the spiders and such and noticing the flame coming out of my cast iron burner is only blue in the bottom half and yellow at the top half. Is this normal? I forget.

 

I already disassembled the whole darn flame box, removed the burner and cleaned out the tube. It just mostly had some rust but I cleaned it out good and with a round brush and blew out any debris with an air compressor. Looks good and went back together fine so am not worried about a spider or bug debris clogging up anything.

 

Is this acceptable?

 

On a related note, in case you can help, my ignitor stopped working after reassembly. I dropped the bottom burn pan so it wasn't connected electrically to the unit and it works. It just doesn't work when grounded again. The little crome plate where you put the holddown screw through is going to touch metal, and thus be grounded. I don't understand why it isn't working.

 

Thanks for any advice

post #2 of 13

Low fuel levels in your tank can cause the flame to be yellow.  Could be as simple as that, hope this helps.

post #3 of 13
Thread Starter 
Full tank. Flame volume seems correct, and on high it quickly brings the smoker up to 400+ if I just let it run.
post #4 of 13

It may just need to burn its self clean. Maybe air needs adj. CF

post #5 of 13

If the igniter doesn't work, the ceramic insulator may be cracked and the spark is grounding through the crack....  The tip of the wire should be next to the gas hole in the burner....  if it is in the gas stream, they won't spark....   don't know why it's just what I have found...

The yellow flame means not enough air entering the venture...   If it has an adjustment plate, open it up a bit...    adjust the air inlet, where you set the flame for most of your cooking...

post #6 of 13
Thread Starter 

Hmmm. Adjustment plate is wide open, with the screens clear of debris and looking in good shape.

 

The burner is in a bottom basket that has plenty of free air flow so there is no obstruction or need to open anything else up.

post #7 of 13
Thread Starter 
A year later and I still have a yellow flame. Bottom has plenty of fresh air. I again ensured no spiderwebs in inlet and made sure burner was unobstructed (took it all apart to do so). Just put some ribs on but feel I don't have the unit burning correctly...confused.gif

post #8 of 13

Does the pressure regulator have an adjustment ???    Turn up the pressure...    turn the knob or screw clockwise.. 

 

What is the upper temp you can get on the unit ??? 

 

What is the lower temp you can run it at ??

post #9 of 13
Thread Starter 
Don't know the max but am able to hit my target temps of 225 to 275 at less than full flow.

Reg is not adjustable. Tank is 75% full.

What should it look like? Just blue?
post #10 of 13

..... 

post #11 of 13
Thread Starter 
So what do you "adjust" on my model unit to correct this? I don't have an adjustable regulator.
post #12 of 13
Thread Starter 

Still having this issue with 50% of my flame being yellow. Today I discovered I could make it almost all blue by moving the manifold a little backwards out of the burner tune. Not out of it, just rearward maybe 1/8" or so. And it gets worse (almost all yellow) when I push it into the tube a little more. When I let it go and it returns to where it sits with no forces exerted it returns to having about 50% yellow flame. This is somewhat helpful as it confirms it isn't the hose or regulator that needs to be replaced.

 

I don't see any kind of adjustment or way to fiddle with it. Any suggestions?

 

post #13 of 13

Something looks broken...

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Propane Smokers
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Propane Smokers › Flame color on Landmann GOSM 3405GLA ?