Yet another first brisket, thanks JJ

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

jetsknicks1

Smoking Fanatic
Original poster
Nov 23, 2011
493
132
Ocala, Fl.
First off, thanks to Chef JJ for his patience and advice. 10# whole brisket that I trimmed and rubbed in SPOG then I wrapped it tight and in the fridge at 8:00. Looking at a 2:00am start and would love for it to be ready to serve at 4:00pm.
Wish me luck. :biggrin:

One stupid question. The point is on the bottom right corner of the top photo?
 
Last edited:
Good luck! Enjoy!

popcorn.gif
 
Help! 7:45 and it's already at 176 IT. I put it in a pan covered in foil and turned the heat down. Looks like this thing is going to be done wayyyy early, how long will it hold wrapped in foil and towels in a cooler?
 
A brisket will get to the 165-175 range very quickly. However they tend to stall around there & could be there for hours.

If you put it in a pan with a foil cover it will cook even faster. Take the cover off.

In a cooler wrapped in foil & towels it will stay hot for 5 or 6 hours.

Al
 
A brisket will get to the 165-175 range very quickly. However they tend to stall around there & could be there for hours.

If you put it in a pan with a foil cover it will cook even faster. Take the cover off.

In a cooler wrapped in foil & towels it will stay hot for 5 or 6 hours.

Al
Thanks Al. Just took the foil off and it's at 190 IT. I was so paranoid about it taking too long, I guess I panicked and started it too early. Good to know it will keep that long.
 
Test for and go by Tenderness. A therm probe should slide in with just slight resistance. IT is an indicator that things are going smoothly but is not the end all be all. I can get a Brisket IT to 200 in 90 minutes at 500°F but that don't mean its going to be Tender! Collagen breakdown and juiciness takes Time. It just happen to be fairly accurate that at a smoker temp of 200 to 250 the IT reaches 195 to 200 when enough Time has passed to make it tender. There is a reason they say go Low and Slow...JJ
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky