Toggle sidebar

Old heavy UDS build

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
muzztang

muzztang

Newbie
Original poster
Mar 15, 2016
2
10
Gippsland, Victoria, Australia
IMG_0118.JPG

IMG_0118.JPG

Hi all. here is my old super strong drum for my UDS build. Have cut the top out and left a 1/2 inch lip at the top and given it a couple burn outs..No notable bad odours, but does anyone know if there is any  issues with the internal coatings of these?
 
Last edited:
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

joepeep77
Barrel for a UDS
Replies
0
Views
726
Smoker Builds
joepeep77
joepeep77
apn73
PID & Fan Recommendations For UDS Build
Replies
4
Views
2K
UDS Builds
Fraser
Fraser
I
Exhaust for my reverse flow build question.
Replies
3
Views
1K
Other Builds
irvin78787884
I
Meniscus
DIY: Introducing the only 'Shorty' version of the Oklahoma Joes Bronco Drum Smoker in existence
Replies
23
Views
4K
Charcoal Smokers
Meniscus
Meniscus
B
Turning a Pellet Grill into a cabinet smoker
Replies
4
Views
2K
Other Builds
Fueling Around
Fueling Around
J
Newer Amerique controller for CS SM066 - almost new
Replies
3
Views
2K
Classified Ads
pattyq
pattyq
seenred
A New Build: 24x30 Vertical Offset - A Custom Build For JLeonard!
Replies
321
Views
19K
Side Fire Box
seenred
seenred
Its_Raw
Old Country Brazos - Few Mods and Some Observations
Replies
0
Views
720
General Discussion
Its_Raw
Its_Raw

Latest posts

Hot Threads

Top Bottom
Back
Clicky