or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Other Builds › 360 degree firebox air manifold
New Posts  All Forums:Forum Nav:

360 degree firebox air manifold

post #1 of 3
Thread Starter 
I was thinking that my fire would burn hotter and more evenly in my offset smoker, if I could divert the air from my pit controller fan all the way around the fire rather than just feed it all to one spot right next to the firebox wall. So I bent up a piece of 1 inch diameter tubing and put holes around the inside that feed the air to the fire from all sides. It seemed to work very well on my first test smoke.




Edited by Skooter - 3/15/16 at 6:43pm
post #2 of 3
Did you do your welding, because that is sweet.
post #3 of 3
Thread Starter 
I did not weld it. I did the bending and machining, luckily I work closely with three exceptional welders. It's all 316 stainless.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Other Builds
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Other Builds › 360 degree firebox air manifold