or Connect
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Thanking about doing a mod
New Posts  All Forums:Forum Nav:

Thanking about doing a mod

post #1 of 5
Thread Starter 
I built my offset about a year ago now and i use one of the online calculators for the build and every thing turned out good all but the exhaust. The calculator said I needed 80" of 2.5 pipe so I made 4 pipes 20" and it gave me way to much draft pulls ash in to the cc and uses way to much wood. So I've been putting a coffee can over two of the pipes as a damper and works great. So I was thinking (with can be a bad thing) that if I moved two of the pipes to the same side as the fb and dropped in a plate 7/8 the length of the fb and put dampers in the pipes I could use it as a offset or a reverse.
post #2 of 5
Thread Starter 
Here are some pic what do yall thing. If i move two of the exhaust and put a plate in the bottom. Yall think it will work?

post #3 of 5
I have no experience with this so I have no technical advice, but based on other build I've seen, that looks like a lot of pipe.
post #4 of 5

Do you have even temperatures across the cooking surface that you are happy with ???

post #5 of 5
Thread Starter 
Before I added my heat defuser at the firbox it was 300ish at ff 150ish ex side after the defuser 275 ff 225 center 190 ex side and the cooker is 58" long. Witch is fine if I'm cooking burgers for lunch and butts or ribbs for dinner. But when I cooking 5-8 butts for me and my friends like I do offten it can be a pain moving them around to get a even cook. I would like to get to about to about 50° differences across or less
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Reverse Flow
SmokingMeatForums.com › Forums › Smoking Supplies & Equipment › Smoker Builds › Reverse Flow › Thanking about doing a mod