texasjason
Smoke Blower
I looked at it this morning and wasn't bent that much to notice in a picture. Like I said I just crimped the sides in a little with some pliers and it fit better.
starting fires and learning the hard way
- Thread starter cukoo bbq
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
So you did it to both sides? Your first post said one side. Im guessing you mean along the top edges then, and not so much along the base/bottom- (just to clarify)
Last edited:
texasjason
Smoke Blower
Yes, both sides at the top part of it. Sorry should have been more clear. Just bent it a little inward which made it not so darn tight of a fit. There is a screw that looks like it attached the housing of the heating element that mine seems to get hung up on until I bent it a little. Could take out that screw too and see if that helps.
texasjason
Smoke Blower
smokeshowingbbq
Fire Starter
Im new to the MES too and was wondering where to place my tray. I have the 40" and was planning on just setting it on the bottom rack either small tray rack above it or tin foil tent to keep juices out. Thoughts?
smokeshowingbbq
Fire Starter
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 57
- General Discussion
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 42
- Blowing Smoke Around the Smoker.
-
Non fat dried milk
- Started by hog warden
- Replies: 37
- Sausage
-
Featured A couple thick strips please!
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
