or Connect
SmokingMeatForums.com › Groups › Masterbuilt Electric Smoker (MES) Owners › Discussions › Smoke Box Door (Wood loader)

Smoke Box Door (Wood loader)

post #1 of 3
Thread Starter 

 I have a problem with it. On the chip loader it does not strop turning when it dumps the chips. And also you can pull it out without turning it to unlock. The tabs seem to be straight. What can I do to remedy this?

 

Thx in aadvance

post #2 of 3

I wouldn't worry about it. It's not going to fall out, and after you dump the chips, just leave it in that position. Or you could do like most MES guys do & buy an AMNPS. 

 

http://www.amazenproducts.com/

 

Al

post #3 of 3
Thread Starter 

Thx, yes I have already bought the AMNPS. I didn't figure it was a problem. Thx again

SmokingMeatForums.com › Groups › Masterbuilt Electric Smoker (MES) Owners › Discussions › Smoke Box Door (Wood loader)