or Connect
New Posts  All Forums:Forum Nav:

AMNPS Elevator Shed

post #1 of 8
Thread Starter 

When using my amnps in my MES I usually have to use a extra rack to elevate it off bottom of smoker and then place foil on the next rack to prevent juices from falling onto pellets. I was thinking of making a device that I could make to elevate it and cover the top without using racks. I'm thinking about a mini multi shelf device that the amnps would fit into. Before I do has anyone else already built one or have any ideas?

 

Also any ideas on easier way to clean racks? 

post #2 of 8

I use the binder clips you can get at Staples

Richie

 

post #3 of 8

This is the mod Made to mine. Four two inch bolts.

 

post #4 of 8
Thread Starter 

I was thinking of something similar but going above the rack about 4-6 inches to build a roof as well

post #5 of 8
Quote:
Originally Posted by meatpacker View Post
 

I was thinking of something similar but going above the rack about 4-6 inches to build a roof as well

 

I only use mine when cold smoking so it does not see the inside of a product chamber/ food box. If you are using yours to hot smoke, which is fine, consider four two inch bolts and four four inch bolts with a piece of sheet metal for a roof. 

 

Keep it simple.

 

T

post #6 of 8
Thread Starter 

How did you attach the bolts?

post #7 of 8
Quote:
Originally Posted by meatpacker View Post
 

How did you attach the bolts?

Drill a hole in each corner large enough to accept the bolt, then place a flat washer, nut and tighten.

 

T

post #8 of 8

Yup!   Very easy mod.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: General Discussion