or Connect
New Posts  All Forums:Forum Nav:

Mypin ta4

post #1 of 2
Thread Starter 

I will admit that I am a beer brewer, and this seems like the best place for help.  My temp controller is setup for testing with a SSR controlling a lamp, but the output led on the PID flashes continuously. This flashes the lamp via the SSR. The temp probe works fine too, so wiring seems OK. I may have messed up a setting trying to change from C-F.

If I wanted to maintain a temp. of 156F, and never allow more than 3F above or below that, what would the settings be for alm1 and alm2?


Edited by Syncman - 1/27/16 at 12:11pm
post #2 of 2

I would post your question in the beer & ale forum.

 

Just go to Forum Nav: find beer & ale then post in there.

 

Good luck.

 

Al

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Smoker Builds