or Connect
SmokingMeatForums.com › Forums › Announcements › Roll Call › Introductory thread
New Posts  All Forums:Forum Nav:

Introductory thread

post #1 of 3
Thread Starter 
Hello everyone, I'm keggy and I'm from Australia. I have begun building my first reverse flow smoker and am at a point where I am a little stuck and starting to think I may have jumped the gun with the opening from the fb to the cc before realising the amount of math needed to work it all out. we use metric sizing over here so I need to get a conversion chart out whenever reading a tread or trying to use the calculator. Any help to work out if I'm on the right track would be very appreciated. thank you in advance and thanks for letting me become a member :)
post #2 of 3

Welcome to SMF! There are a lot of talented builders on here. Post your questions in the RF build forum.

 

Al

post #3 of 3

texas.gif  Good afternoon and welcome to the forum, from a pretty nice day here in East Texas, and the best site on the web. Lots of great people with tons of information on just about  everything.

 

Gary

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Roll Call
SmokingMeatForums.com › Forums › Announcements › Roll Call › Introductory thread