Gen3 mes30?

Pauliepaul said:

Bearcarver said:

Hi Paul,


It should be easy to level with the adjustments at the feet and/or wheels.



Tip:  IMHO---Water in the pan doesn't do anything good in an MES unit.




Bear

Click to expand...

there is no adjustment whatsoever on the feet of the unit. Im not so concerned about water, more about the unit is brand new and wobbles like a penguin on my back porch.

Click to expand...

Dr K said:

Now that it is standing upright if you loosen the stretcher bolts between the four legs you can probably get it level and tighten them back up.
-Kurt

Click to expand...

lacough said:

 
I was going to say the same thing. Mine is also not setup perfectly yet, but I had a backlog of smoking projects, so I wanted to so them first! I have found another issue.....My AMNPS does not fit on the lower left. The chip burner (element) and its housing protrude to far for it to fit. I have it on the first rack today, But I need to figure something else out!

The joys of smoked meat addiction!

-Dave

Click to expand...

Brickguy221 said:

 
If it is the Maze that won't fit, try one of the Tubes sold by Todd. They don't burn as many hrs (approx 4 vs 10) as the Maze, but they should fit.

Click to expand...

lacough said:

 
Oh, I have a 12 inch tube from Todd as well! I like the maze for longer smokes.....

Maybe Todd Needs to make a version 2 of the maze to fit the gen 2.5!!!!!!!

Click to expand...

Brickguy221 said:

 
I have the Gen 2.5 BT and my Maze fits just fine on the left side and raised about 1 1/2' - 2" sitting on a wire rack the same size as the Maze off the bottom pan.

My 2.5 is a 40" ... Is yours a 30"???? ... If so, then that would make a difference.

Click to expand...

lacough said:

 
yes, its the 30" 2.5. That is most certainly the difference. I actually tried to sit it on a rack, but again, not enough clearance. less than 1.2 inch off from being perfect.....GRRRR

Click to expand...

Pauliepaul said:

 
its more of a matter of principle with me

Click to expand...