I'm in the planning stages of building a UDS, basically till I can afford the hardware, ie valves bolts etc.
My question is how can I go about prepping the lid?
It has a two inch bunghole and a smaller one (maybe an inch) that I figure I'll use as exhausts.
My issue is prepping the lid. It's too big to fit inside the drum when I burn out the drum, so what's a good way to remove the paint off the lid? Also there is a rubber gasket, how would ya recommend I remove it?
Thanks y'all.
Josh.
My question is how can I go about prepping the lid?
It has a two inch bunghole and a smaller one (maybe an inch) that I figure I'll use as exhausts.
My issue is prepping the lid. It's too big to fit inside the drum when I burn out the drum, so what's a good way to remove the paint off the lid? Also there is a rubber gasket, how would ya recommend I remove it?
Thanks y'all.
Josh.